Certificate of Analysis-COA
Test Item | Requirement | Test Result |
1. Appearance | Colorless or light yellow clear liquid | PASS |
2. Solid Content(wt) | ≥98.0% | 99.84% |
3. Color (Pt-Co) | ≤60APHA | 20APHA |
4. Viscosity @25 deg. C | 80-120cps | 110cps |
5. Acid Value | ≤1.0mg KOH/g | 0.23mg KOH/g |
6. Moisture (K.F) | ≤0.2% | 0.03% |
CONCLUSION | QUALIFIED |
Applications
1. UV/EB Industrial & Wood Coatings — furniture and parquet topcoats, industrial metal coatings: A trifunctional crosslinker that raises crosslink density sharply, delivering fast cure, hardness, solvent resistance and improved stain and chemical resistance in the cured film. Used at modest levels to lift performance without replacing the main diluent.
2. Plastic & Metal Hardcoats — scratch- and abrasion-resistant coatings, optical and display films, appliance surfaces: Builds a dense, hard, glossy network that resists abrasion, rubbing and cleaning chemicals, which is what a hardcoat is judged on. Also improves adhesion and surface hardness on treated plastics.
3. UV Inks & Overprint Varnishes — screen, flexo and offset inks, OPV for packaging: Increases cure speed and film toughness and improves adhesion and resistance in the printed film, allowing higher line speeds and better rub resistance in the finished print.
4. Photoresist, Solder Mask & Colour Filter Resists — photoimageable solder mask, colour filter and black matrix resists, dry-film resist: A standard multifunctional crosslinker in imaging resists, providing the crosslink density that fixes the exposed image, gives chemical resistance through development and stripping, and holds dimensional stability through bake.
5. Adhesives — Electronic, Laminating & Structural — UV structural adhesives, electronic assembly adhesives, laminating adhesives: Raises cohesion, heat resistance and creep resistance of the cured adhesive, allowing a low-viscosity, highly filled formulation to reach structural performance after a rapid UV cure.
6. 3D Printing & Photopolymer Resins — SLA/DLP resins, tough and rigid engineering resins: Increases crosslink density to raise strength, stiffness and heat resistance in the printed part, and accelerates cure for shorter layer exposure. Usually blended with monofunctional diluents to balance brittleness.
Production Line
We operate 10+ production lines, backed by a well-stocked raw material warehouse.
Our workshop is equipped with automated machinery — ensuring high consistency and precision on every order, from trial samples to full container loads.
Every order follows a standardized workflow. Key quality control points are set at every stage.
Factory Area
Standardized Process Flow
Production Capacity
Located in Shandong, our factory is approximately 300km from Qingdao Port, enabling fast and cost-effective delivery to customers worldwide.